top of page

ISC® VSI Crusher Benefits

  • Cubical Particle Shape

  • Reduced HP Requirements

  • Circuit Simplicity

  • Low Capital Investment

  • Non-Plugging Chamber

  • Consistent Gradation

  • High Capacity

  • High Fracture Count

  • High Product Yield

  • Production Beneficiation

  • Gradation Control

  • Variable Reduction Rations

ISC® VSI Crusher Standard Design Features

  • Adjustable Feed Splash Plate with replaceable cast liners for directing and centering the feed.

  • Cast Lined Rotatable Feed Box.

  • Externally Adjustable Feed Tube Assembly with Rubber Dust Seal and cast Feed Tubes.

  • Quick release Lid Wedges with Chain Tie Downs and Safety Hitch Pin Clip.

  • Hydraulic Lid Lifter Assembly with Limit Switch and Safety Lock Pin.

  • Lid with hinged rubber sealed Inspection Doors with wedge lock latch bar and safety lock pin.

  • Bolt-on Upper Tub Assembly allowing flexible 90° re positioning of Hydraulic Lid Lifter Assembly

  • Main Frame construction with Square Base Plates, Dual Opposing Drive Tunnel Bolt Plates, and bolt-in Lube Block Plates.

  • Cast segmented liners to fully protect Lid, Tub, Drive Tunnel, and Pedestal.

  • Heavy Duty Pedestal Mount Plate

  • Heavy Duty Pedestal with Timken Tapered Roller Bearings, Dual Upper and Lower Double Lip Oil Seals, Chrome Wear Sleeves, and HTSR Shaft.

  • Gravity Flow Oil Lubrication System for positive oil flow and improved bearing protection.

  • Lubrication sensing devices for Oil Flow and Oil Temperature.

  • Flywheel fully lined and protected with cast segmented liners on bottom and outer edge.

  • Heavy Duty Impeller Tables with multiple Bolt-on Impeller Shoes.

  • Cast segmented Top Table Plate Assembly for optimum crushing efficiency.

  • Variable Design Impeller Shoes with Ramped Table Liners and Bolt-in Feed Discs.

  • Vertically Adjustable and Indexable Heavy Duty Anvil Ring with Slip-in Individual Dovetail Anvils.

  • Bolt-on Motor Tunnels with single Tube in a Tube Adjustment Take-up and removable V-Belt Safety Guard.

  • Drive Motor Mount with Motor Cover.

  • Variable sensitivity Vibration Switch.

  • Bolt-on Tub Access Ladders.

  • Sheaves, Bushings, and V-Belts for required Table speed and proper V-Belt Service Factor

ISC® VSI Crusher Optional Design Features

  • Lube Wiring Package

  • Lube Starter Control Panel

  • Oil Tank immersion Heater

  • ISC® Water Spray System for sticky wet applications

  • ISC® Fog Mist Spray System for dust control

  • Rotatable Anvil Ring Lifter Beam

  • Rotatable Parts Service Beam for Trolley and Hoist

  • ISCeramics® for Shoes, Anvils, and Feed Discs

  • Enclosed Rock Shelf with cast liner protection for shaping applications

  • Dual Electric Drive

  • Stationary Support Frames with Discharge Conveyor

  • Portable Chassis Mounts with Discharge Conveyor, Feed Conveyor, and/or Hydraulic Leveling Legs

  • Electric Drive Motors, Starter Controls, and Variable Frequency Drives

  • Diesel Engine Power Units

bottom of page